Walkera22e_24ghz_brushlessmaininstallation

1. Remove the Canopy Cover.
2. Disconnect the Main carbon brushed motor from the Rx.
3. Remove the 370 carbon brushed motor. Use a small
phillips screwdriver and remove. There are two small screws
that hold the carbon brushed motor and need to be removed.
4. After removing the main carbon brushed motor
5. Next, install the new Main Brushless motor. Use the
mounting holes that the screws are in already. The other two
holes are further apart and won't fit properly.

Finished view of the Main Brushless motor kit installed with Super Skids 200 and adapter 22 in the Walkera #22E/Exceed
Eagle 50 (2.4Ghz version)

If you still have problems installing, please e-mail us at sales@rtf-heli.com

Walkera #22E / Exceed Eagle 50
Main Brushless Motor Installation Instructions
(2.4GHz Version Only)

Parts List:

(1) Brushless motor with progrmmable ESC and 11t pinion installed and pre-wired
(1) 11.1 volt 1,000Mah 20c LIPO Battery (recommended)

6. Wrap the ESC and other wires around the opposite
side of the landing gear away from the attenae wires.

7. Connect the Signal Converter (RED, BLACK) wires
into WALKERA #22E SPEED CONTROLLER PORT that is
marked as MAIN MOTOR INPUT. This is the same
connection that was used to connect the STOCK MAIN
MOTOR.

Be careful not to damage the Signal Converter by
squeezing the unit. It is a very DELICATE electronic
piece of equipment. The signal converter is the small
piece shown below.

8. Next, connect the small banana plug into the POWER INPUT
of the Walkera #22E ESC. .

9. Finally, turn on the TX and connect the long end
(RED/BLACK) connector labelled "Connect to LIPO Battery" to
the LIPO Battery. (Note: If your LIPO Battery uses a bannana
plug or a Deans Plug goto: LIPO Battery Adapters to get an
adapter plug)

10. You are done, throttle up slowly to get the feel for the
brushless motor.