| . |
1. Remove the Canopy Cover.
2. Disconnect the Main carbon brushed motor from the Rx.
3. Remove the 370 carbon brushed motor. Use a small phillips screwdriver and remove. There are two small screws that
hold the carbon brushed motor and need to be removed.
4. After removing the main carbon brushed motor
5. Next, install the new Main Brushless motor. Use the mounting holes that the screws are in already. The other two holes
are further apart and won't fit properly.
2. Disconnect the Main carbon brushed motor from the Rx.
3. Remove the 370 carbon brushed motor. Use a small phillips screwdriver and remove. There are two small screws that
hold the carbon brushed motor and need to be removed.
4. After removing the main carbon brushed motor
5. Next, install the new Main Brushless motor. Use the mounting holes that the screws are in already. The other two holes
are further apart and won't fit properly.
Finished view of the Main Brushless motor kit installed in the Walkera #22E/Exceed Eagle 50
(35 MHz/72MHz version.)
(35 MHz/72MHz version.)
Please read our Store Policy and Privacy Policy. - Contact US - Copyright © 2009 - 2011 RTF-HELI.COM
Advertisement
If you still have problems installing, please e-mail us at sales@rtf-heli.com
| Walkera #22E / Exceed Eagle 50 Main Brushless Motor Installation Instructions (35 MHz / 72 MHz FM Version Only) |
| . |
Parts List: (1) Brushless motor with progrmmable ESC and 11t pinion installed and pre-wired (1) 11.1 volt 1,000Mah 20c LIPO Battery (recommended) |
| . |
MOTOR ESC CONNECTION
ESC Signal Wire (CONNECT TO PORT #4) -->>
ESC Signal Wire (CONNECT TO PORT #4) -->>
6. Wrap the ESC and other wires around te opposite side of the landing gear away from the attenae wires.
7. Connect the ESC signal wire (RED, BLACK, and WHITE) wires into PORT 4 of the Rx. Make sure that the signal wires are
the same with the servo wires when lined up.
8. Replace POWER input of the Rx with provided JST Connector. Solder (60/40 TIN/LEAD) RED to RED and BLACK to BLACK
wires. Use the heat shrink tubing over connections and use a match and heat up tubing until it shrinks over bare
connections. Then connect to the short (RED/BLACK) JST Labelled "Connect to RX Power Input"
9. Use the nylon tie wraps to secure the ESC and power wires to the Landing Gear.
10. Finally, turn on the TX and connect the long end (RED/BLACK) connector labelled "Connect to LIPO Battery" to the LIPO
Battery. (Note: If your LIPO Battery uses a bannana plug or a Deans Plug goto: LIPO Battery Adapters to get an adapter plug)
11. You are done, throttle up slowly to get the feel for the brushless motor.
 |
| FAST SHIPPING AS WE ARE LOCATED IN THE U.S. |
| . |
| . |
| . |
| . |
Installation Menu |
| . |
 |
 |
 |
 |
 |
 |
 |
 |
RTF-HELI.COM
"The place to shop for modifications to your R/C Electric Helicopter"
"The place to shop for modifications to your R/C Electric Helicopter"
|
| INTERNATIONAL ORDERS WELCOMED FAST SHIPPING FOR U.S.ORDERS |